If the washer stops mid cycle the lid switch assembly might be defective. This is a very common problem. The lid switch assembly can fail either mechanically or electrically. Most washers have a cold water rinse and so if they can't fill with cold water they just sit indefinitely waiting for the cold water to enter.Likewise, how do you fix a washing machine that stops mid cycle?
Replace the lid switch if it doesn't detect a closed lid. A broken timer or failed water-level pressure switch will also stop a top-load washer in mid-cycle. On a vertical modular (VMW) top-load washer, a bad shifter assembly or a failed drain pump can stop the washer mid-cycle.
Subsequently, question is, why does my washer keep shutting off? Avoid overloading the washing machine, which may cause the motor to overheat and shut off. Many washing machines now have several automatic features, such as automatic detergent dispensing, automatic time and soil sensors, automatic load size sensors and water level adaptation, and even automatic energy saving modes.
Accordingly, why is my washing machine not finishing the cycle?
Drainage Problems. If the washing machine doesn't drain properly then something blocking the pump could have caused the washer to stop mid cycle. General overheating is again a possible cause for your washer to stop mid-cycle, many washing machines have built-in sensors.
Why does my washing machine get stuck on the spin cycle?
If you have a GE washer that's stuck on its spin cycle, you'll need to reset the machine. This is because the appliance is full of water during this cycle, and merely turning off the washer will leave it filled with water. Next, plug the washer back in and lift the lid six times in 12 seconds.
How long does a washing machine last?
The average life expectancy of a new washing machine is 11 years. Consumer Reports recommends replacing any appliance that's more than eight years old, unless it's a high-end model and has a particular appeal to you. Others suggest replacing any top-loading washer manufactured in 1999 or earlier.Where is the inlet valve on a washing machine?
The inlet valve can be found on the back of your washing machine. Its principal responsibility is to manage the entry of water into your washing machine. In other words, the inlet valve acts as a sort of gate keeper, allowing water to flow into the tub when it receives certain electrical signals from the washer.How do you fix a washing machine that won't drain or spin?
Check for clogs in the drain hose and drain pipe Set the washer in the spin mode and see what happens. If the water won't drain, turn the machine off, pull the drain hose out of the standpipe and check for a clog at the end of the hose. Sometimes lint or debris can build up in this area and prevent draining.Why are my clothes still soaked after washing?
If the drain hose on the back of your washer is too far down or not down far enough in the standpipe, this can cause an issue with proper draining and can cause the washer to not fully drain out the water and therefore your clothing will still be soaking wet after a wash cycle.How do you reset a Samsung washer?
To reset your Samsung washing machine you need to simply disconnect the washing machine from power for 5 to 10 minutes. (Unplug the washer from the wall outlet or flip the breaker in the breaker box for the washing machine). 
