For an average 40-foot boat, Cockerill estimates about $100 per foot to re-rig with wire rigging ($4,000), as well as the round-trip cost to haul and launch the boat and unstep and step the rig (an additional $2,500 or so).Besides, how much does it cost to replace the standing rigging on a sailboat?
As a general cost guideline, replacing the standing rigging on a typical 30 footer with 1/4" wire rigging will cost about $1,200. That price includes turnbuckles but not unstepping the mast. The cost of replacing the standing rigging on a 40-foot cruising boat with 3/8" wire could be almost twice as much.
Also Know, how often should you replace standing rigging? Most insurance companies reckon you should replace your standing rigging about every 10 years. Sometimes they let you go longer if you have the rig professionally inspected, particularly if you have an electronic check carried out on the terminals and other crucial fittings.
Keeping this in consideration, how long does sailboat rigging last?
10 years
What are stays on a sailboat?
Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts. A stay is part of the standing rigging and is used to support the weight of a mast. Thus stays are fore and aft.
What is running rigging on a sailboat?
Running rigging is the rigging of a sailing vessel that is used for raising, lowering, shaping and controlling the sails on a sailing vessel—as opposed to the standing rigging, which supports the mast and bowsprit.How do you inspect a sailboat rig?
Start with the wire at eye level, and scan downward, checking for rust and broken strands. For rod rigging, we're looking for cracks or corrosion. Take a good look for corrosion where the wire enters the swage or mechanical fitting. Next check the t-bolts, tangs, turnbuckles, and pins.What is a Chainplate on a sailboat?
A chainplate is a metal plate used to fasten a shroud or stay to the hull of a sailboat. One end of the chainplate is normally fastened to a turnbuckle which is connected to the shroud or stay, whereas the remainder of the chainplate normally has multiple holes that are bolted to the hull.How tight should sailboat shrouds be?
Usual rule of thumb is that the leeward shrouds should not go slack in less than 15 kts w/ the #1 headsail up. But it varies from boat to boat. Primary shrouds and stays should be tensioned to 15 to 20% of their rated breaking strength. To tension the shrouds properly you will want to buy a Loos gauge.How often do sails need to be replaced?
5-10 years
What are shrouds on a sailboat?
On a sailing boat, the shrouds are pieces of standing rigging which hold the mast up from side to side. Usually a shroud will connect at the top of the mast, and additional shrouds might connect partway down the mast, depending on the design of the boat.What are cap shrouds?
Cap Shrouds These are the parts of a sailboat's rigging that hold the mast in place athwartship. They're attached at the masthead and via chainplates to the hull.What are spreaders on a sailboat?
A spreader is a spar on a sailboat used to deflect the shrouds to allow them to better support the mast. Often, there are multiples, called spreaders. The spreader or spreaders serve much the same purpose as the crosstrees and tops in a traditional sailing vessel. 
