There is a shut-off valve running parallel with the pipe, usually located about 6 to 8 inches above the ground. Take a 12-inch or larger adjustable wrench, and turn the valve 1/4 turn in either direction, until the valve is crosswise to the pipe.Also to know is, how do you turn off the main gas?
Locate your main gas service shutoff valve. It's usually the first fitting on the natural gas supply pipe coming out of the ground next to the meter. With a wrench, turn the lever in either direction until it is crosswise to the pipe. Once the gas is turned off, leave it off.
Furthermore, what does a gas shut off valve look like? In newer homes, the gas shut off valve may look like a bright yellow lever on a black iron pipe where the gas supply line enters your house. To turn off the gas, just turn the lever perpendicular to the line, and then turn it parallel to the line to turn the gas back on.
Then, can I turn my gas back on myself?
Once the valve is turned off, do not turn it back on by yourself. It must be turned on by a gas company technician. The gas company will likely perform a pressure test on the system and relight all pilot lights in the house as part of turning the gas back on.
How long does it take gas to dissipate?
About 5 minutes is plenty. Just make sure to read up on how many threads the gas lines should be.
Where is the main gas shut off to my house?
Houses with natural gas have a main shutoff valve (Fig. A) located just before the gas meter. This valve, often called the street-side valve, is normally a rectangular nub (Photo 1). When the long side of the nub or handle is parallel to the incoming gas line, it's open and the gas is flowing.How does the gas company turn on the gas?
The gas company turns on the gas by placing an adjustable pipe wrench onto the tang and moving it from its horizontal (closed) position a quarter turn (usually either direction), so that the tang is now vertical. Turning off the gas is as easy as turning the tang with the wrench back to the horizontal position.How do you reset a natural gas regulator?
To reset the unit, unscrew the transparent plastic cap, and pull the shaft outwards - you will hear the gas flowing through, and hold it out for a couple of seconds until the gas re-pressurises the downstream pipework. Replace the transparent cap. If it has reset properly, you won't see the red marker anymore.What happens if you cut the lock off your gas meter?
The danger is being sloppy when you cut the lock off and cutting the gas pipe as well, causing an explosion. Even if you cut the lock off, and turn the valve to the ON position, the gas will still be blocked by a solid washer (disc) placed in the inlet or outlet sleeve coupling located next to the meter body.Why is my gas not working?
Problem: It's clogged with food debris Whether it's grease buildup or food crumbs, one of the most common causes for a gas burner that has trouble igniting is debris blocking gas flow to the igniter. Finally, clean any remaining debris out of the burner holes with a toothpick, sewing needle or compressed air.What does a gas meter look like?
Typical natural gas meters look a lot like electricity meters but with only four dials (some can have up to six). Dials one and three spin counter clockwise, while dials two and four spin clockwise. The dials spin from the force of the moving gas in the pipe and spin faster as the flow increases.How do you know if a valve is open or closed?
When the handle of a ball valve is parallel to the valve or pipe, it's open. When it's perpendicular, it's closed. This makes it easy know if a ball valve is open or closed, just by looking at it.Is it safe to disconnect a gas stove?
How to disconnect a gas stove? The safe way is to first turn off the gas. This can be easily done with the gas meter or the shut-off isolation valve. If there is no other shutoff valve found on the supply line close to the appliance, you will need to turn off the gas supply to the entire house. 
