How do you take the door panel off a 1998 Ford Expedition?

step 1: Remove the door panel (1:00)

1. Remove the triangle panel by prying up with a screwdriver and cloth.
2. Pry up the switch panels and unplug the wiring harness.
3. Pry up the courtesy light.
4. Unscrew the three screws securing the panel.
5. Remove the door handle latch bezel.
6. Lift the door panel up and off.

Similarly, you may ask, how do you take the door panel off a 1998 Lincoln Navigator?

How to Remove a Lincoln Navigator Door Panel

1. Pull up on the trim piece along the upper back edge of the window to remove it from the door.
2. Locate the door release on the inside of the door.
3. Look for a bolt behind the plastic cap.
4. Pry off the mirror triangle trim piece on the upper right corner of the driver's-side door and remove the push-pin fastener.

Also Know, how do you remove the door panel on a 2001 Ford Expedition? How to Remove a 2001 Ford Expedition Door Panel

1. Open the door as wide as possible to give you room to work.
2. Place the flathead screwdriver in the blade slot underneath the lighted reflector in the corner of the door panel and pop out the lens.
3. Open the door handle and use the flathead screwdriver to pop out the trim ring that goes around it.

Also to know, how do you remove the door panel on a Ford Excursion?

First, remove the electric lock and window switch module from the door panel by carefully prying in an upward motion. The module is shown here just after it came out of its' mounting position. Notice that the window is in the up position. Two screws hold the panel to the door and the panel will lift off.

How do you remove an interior door panel?

Start by removing the window and power lock control panel. Pry it off with a screwdriver and then unplug the wires from it. Use a screwdriver to remove any screws holding the panel to the door. Grab the panel with both hands and pull it straight out to remove it.

How do you remove the door panel on a 2002 Ford Expedition?

Removing 2002 Expedition door panels

1. NOTE: Release the top portion first.
2. Remove the window regulator switch plate.
3. Disconnect the electrical connectors.
4. Remove the upper door trim panel screw.
5. Remove the door trim panel screw at the window regulator switch plate opening.
6. Remove the door trim panel screw in the courtesy lamp housing.

How do you change the inside door handle on a 2003 Lincoln Navigator?

how do you replace a 2003 Lincoln Navigator front passenger interior door handle?

Remove the front or rear door trim panel.

1. Remove the door handle insulator.
2. Position the watershield aside. Remove the interior door handle.
3. Release the cable from the handle.

How do you remove the door panel on a 2002 Ford Explorer?

Step 1 Removing Panel #1 First, the small panel behind the door handle/lock needs to be removed. There are two clips located on the forward portion of the panel; wedge a flathead screwdriver behind this portion of the panel and pry it loose. Once it is loose, you can use your fingers to pull it the rest of the way out.