Lighting Instructions: - Turn the gas knob clockwise to the off position.
- Wait five (5) minutes to clear out any gas.
- Find pilot located in front of back log.
- Turn gas knob counter-clockwise to pilot.
- Depress slightly and hold gas knob while lighting the pilot with the push button igniter.
Also to know is, how do I light the pilot on my gas fireplace?
Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot tube. The pilot should start as soon as the flame is close enough. Hold the pilot button down for about 20 seconds to give the thermocouple time to heat up, then release it. The pilot should stay lit.
Additionally, how do you clean a pilot light on a gas fireplace? How to Clean a Pilot Assembly on a Propane Fireplace
- Turn off the fireplace if it is on and shut off the main gas valve.
- Use a flashlight to look into the tube where the pilot flame comes out.
- Use a can of compressed air to blow the dust and dirt off of the end of the innermost tube.
- Turn the gas valve back on and attempt to light the pilot.
Also asked, should the pilot light always be on in a gas fireplace?
Electronic ignition is when the pilot light on a gas fireplace/insert/stove is only running when the fireplace is on, this means that the unit is likely to have a battery backup as well. A standing pilot is always on, always using a small amount of gas to run constantly unless the gas is physically turned off.
What happens if the pilot light goes out on a gas fireplace?
When a pilot light goes out on a gas fireplace, there is cause for concern if the gas flow hasn't been interrupted. More commonly, a pilot light will go off because of a failure in the supply of gas. One thing to check is the gas valve on the fireplace and make sure it's open.
Is it safe to leave gas fireplace pilot on?
Leaving the gas on keeps this compound moving out of the tubes. Keeping the pilot light on will also keep moisture out of the unit and in turn, help prevent corrosion. As you can see, it's probably best in most cases to extinguish the pilot light in your gas fireplace during the months when you don't need heat.How do I know if my gas fireplace is working?
You should: - Inspect the glass doors for cracks or latch issues.
- Check that gas logs are in the proper position.
- Turn gas off at the shut-off valve and test the igniter.
- Ignite the fire and look for clogged burner holes. If present, turn off gas and clear obstructions with a pin or needle.
How do you start a gas fireplace for the first time?
To light your gas fireplace, first access its control panel and turn the shutoff valve so the handle is parallel to the gas line, which will allow gas to enter your fireplace. Then, move the control knob to the “pilot” position.How do you turn on gas logs?
How do you light a gas log safety pilot? You turn the control knob to the pilot position, push the knob in, light the pilot with a match, then hold the knob down for 30 seconds or so until the pilot stays lit by itself. Once the pilot light will stay lit on its own, you can then move the knob to the "On" position.Why won't my gas logs light?
1. Pilot light systems are the most common reason gas fireplaces fail to light, so check the main gas valve to make sure the gas is turned on. It should usually run parallel to the gas line when it is on. The pilot lights, but not staying lit, indicates that the thermocouple is worn out or bad.How big should my pilot light be?
A proper pilot flame should be blue with a yellow tip and should be strong enough to cover about 1/2 inch at the end of the thermocouple tip. If the flame is too strong and improperly adjusted, it will be blue but may be noisy and lift off the thermocouple, causing improper furnace operation.Is it OK to leave gas fireplace on overnight?
It usually runs all night. However, unvented gas fireplaces (aka vent free, ventless) can adversely affect indoor air quality and shouldn't be used more than a few hours at In most cases, if your fireplace was installed properly, you can leave it on indefinitely.Should I turn off fireplace pilot light in summer?
Here are good reasons to turn off your gas fireplace pilot in the summer: When your pilot light remains on, a small amount of heat is generated. The glass doors on your gas fireplace remain warm to the touch. A by-product of the burning pilot light, the sulfur can continue to build upon the glass.Can a pilot light cause carbon monoxide?
Carbon monoxide is a colorless, odorless gas produced during burning fuel. It doesn't leak from a pilot light that's gone out, but if the light keeps going out even after you relight the pilot, it can indicate that you have other problems.Can a pilot light flame be adjusted?
Adjusting the Pilot Flame If the pilot flame is too small, you may be able to make it larger by turning the pilot adjustment screw on the valve control counterclockwise with a screwdriver to open it. The cause of a weak flame may also be an obstruction in the pilot tube.Can I turn off pilot light on gas fireplace?
We recommend that you turn off your gas fireplace pilot light seasonally. Turning off your gas fireplace's pilot light can save a substantial amount of energy and money. It is important to remember that not all gas fireplaces have “standing” pilot light, or, a pilot light that is “always on”.How do I light a gas fireplace?
Turn the knob from the “Off” to the “Pilot” position. Push in the pilot knob, which manually sends gas into the system. Push the igniter button once every second until it lights. Depending on how long it's been since the gas fireplace was last used, ignition may take multiple attempts.Do gas fireplaces need to be serviced?
The initial and foremost guideline of any gas fireplace system is to have it inspected every year. With professional chimney companies, you can usually have your annual chimney cleaning and gas inspection scheduled at the same time. Matter of fact, your whole system should be inspected annually, top to bottom.Does gas leak if pilot light goes out?
When the pilot light goes out, it does not leak carbon monoxide gas. However, if the light goes out frequently there could be other issues.Can you get carbon monoxide poisoning from a gas fireplace?
Yes, gas fireplaces are one potential cause of carbon monoxide poisoning. An improperly maintained or ventilated gas fireplace, however, can result in incomplete combustion, creating carbon monoxide, and causing this toxic gas to linger—putting those inside at risk of carbon monoxide poisoning.Is it cheaper to run a gas fireplace or the furnace?
Choosing to turn on a gas fireplace or a gas furnace really depends on what you want to accomplish. Usually it is more fuel efficient to have the fireplace on because it doesn't lose any heat traveling through ductwork, but that also means the heat is localized and won't warm the entirety of a large house.Can you run a gas fireplace continuously?
Most fireplace inserts can be run continuously, as long as the glass front is sealed. Most direct vent gas fireplaces can be run continuously, as long as the glass front is sealed. Vent-free: A vent-free gas fireplace is designed to operate similarly to an oven, providing a secondary heat source that is not vented. 
