How do you install a splitter rod?

Installation Procedure:

Line up both edges of bumper and splitter, and temporarily clamp the assembly together on both sides.
Use an 8mm (1/4”) drill bit to drill mounting holes through the Splitter and bumper.
Install the Splitter support rods.
Install additional support brackets as needed.

Thereof, how do you mount a splitter rod?

How to Install Front Bumper Lip Strut Rod Support Bars

Step 1: Drill Holes Onto Your Lower Bumper Lip.
Step 2: Extend the Front Bumper Lip Strut Rods to Your Ideal Length.
Step 3: Mount the Front Bumper Strut Rod to the Bumper Lip's Drilled Holes.
Step 4: Drill Holes on Your Marked Location.
Step 5: Conclusion.

Also Know, how much does it cost to install a front splitter? The splitter only costs $500 so paying more than half to get installed when it comes with a kit to install it seems strange. I mean the breakdown says 2.5 hours to drill holes in the bumper.

One may also ask, do you need splitter rods?

Rods aren't truly necessary, but definitely have a purpose- especially if you race. They help support the splitter with the downforce it'll have pushing down on it, and also help level it out. Without the rods it is possible for it to flex while driving or crack.

What are Splitter rods for?

A car splitter is a rigid extension that's added to the bottom of the front bumper. It looks like a flat scoop that extends out in front. Splitters sometimes have support rods that are attached between the splitter and the bumper. They reinforce the splitter and keep it parallel to the ground at speed.

Where do you mount a splitter support rod?

These mounting points include, but are not limited to: front support rods, bolts/nuts to the front bumper or front air dam, rear supporting L brackets, center support brackets, etc. Larger Splitters will need more support than smaller Splitters will need.

How do you secure a front splitter?

4 Ways To Protect Your Front Splitter

Reinforce the Splitter. You can reinforce your splitter, so that if you bang it on something, it doesn't break.
Install a Splitter Made From ABS Plastic.
Cover the Entire Splitter in Transparent Film.
Add a Lightweight Protection Strip to the Splitter.

What is a splitter on a car?

A car splitter is a modification to the body of the car that is usually found at the front, attached to the bottom of the bumper. Splitters look like a flat scoop that extends out from the bottom of the front of the car. Well, when a car reaches high speeds, air pressure builds up at the front of the car.